PDA

View Full Version : am i close on jetting??



exracer416
04-28-2007, 12:53 PM
removed the choke, chm slip on, stage1 cam, uni filter. 160 mainjet, dynojet, 42 pilot jet. still breakin iin the cam. seems to have good power all around. when i really stab the throttle off of idle it kinda sputters a little but i think it did that stock. whats everyone think??? thanks

hornetgod13
04-28-2007, 01:13 PM
If you are using a Dynojet adjustable needle with a keihin main jet I bet that's your problem. I had the identical problem until switched to a stock keihin adjustable needle. If you still have your stock needle installed than try lowering the clip to the next slot on the needle.

exracer416
04-30-2007, 08:50 PM
well i did a little more messing around i went to adjust the needle and it only had one slot on it! dont know what kind that was but i put another one i had in it and set the clip in the middle. im also at the same 42 pilot jet, and 160 main i think i need to go one size bigger on the main jet cause it cuts a little bit when i stab the throttle, i am using a dynojet jet kit. thats for the help hornet!

hornetgod13
04-30-2007, 09:04 PM
You will always have that "stubble" with a dynojet needle and keihin main jet combo. The Dynojet needle is made for Dynojet main jets. You neede to switch to a 1999 to 2004 stock (adjustable) needle.

exracer416
04-30-2007, 09:48 PM
i think it may be the stock needle out of my old carb, ill know tomorrow, i have to adjust the valves and such, still not that much faster than my sisters 03....

mcleod
04-30-2007, 10:25 PM
oups forget about that, i made a mistake