stever250r
04-22-2007, 12:40 PM
Heres the latest pictures of my project after installing the new cylinder. My custom seat cover will be done this week and I will post some pictures of that as well. If done the way I wanted it should be nice.
The good news.. after 3 years... and starting with nothing but a frame its finally running and all I really have left to finish it is fullbore plastics, chrome tank cover,front and rear shocks, and a few misc. items like sprockets, brackets, graphics, skid plate.
The bad news... If purchased new I still need about 2500-3000 $ to finish it the way I want. It might be next summer before It actually sees the track. Its hard not to settle.. but Ive come too far to do that now.
Heres the list of Mods.
Chassis: http://s152.photobucket.com/albums/s178/SteveR250R/
Arens Frame
Houser +3+1 Arms
Houser swingarm
X-Factor nerfs
Roll Design Race pegs
AC Bumper
? Grab Bar
LSR Axle with antifade and twin row carrier
LSR +1 Stem
Light Speed Racing billet front hubs
Douglas Billet Beadlocks
Aluminum Shrouds
Rath Racing Cylinder guard
Renthal Bars
TM Designs Guide and Slide
Custom seat cover by Cosmic Quads
Controls:
RTC Levers
Moose throttle
Spider Grips
Powermadd hand guards
Pro Design Shorty shifter
Pro Design kill switch
Denton Stabilizer
Engine:
New case halves
New Crank
All new bearings and seals
New clutch with 89 update
Lightened Flywheel
ESR 265 PV Cylinder w/Midrange port
Sparks TT Pipe and Silencer
Billet Exhaust Flange
Billet Case Saver
Boyesen Reed Cage
38mm AS Carb
K&N Filter
The good news.. after 3 years... and starting with nothing but a frame its finally running and all I really have left to finish it is fullbore plastics, chrome tank cover,front and rear shocks, and a few misc. items like sprockets, brackets, graphics, skid plate.
The bad news... If purchased new I still need about 2500-3000 $ to finish it the way I want. It might be next summer before It actually sees the track. Its hard not to settle.. but Ive come too far to do that now.
Heres the list of Mods.
Chassis: http://s152.photobucket.com/albums/s178/SteveR250R/
Arens Frame
Houser +3+1 Arms
Houser swingarm
X-Factor nerfs
Roll Design Race pegs
AC Bumper
? Grab Bar
LSR Axle with antifade and twin row carrier
LSR +1 Stem
Light Speed Racing billet front hubs
Douglas Billet Beadlocks
Aluminum Shrouds
Rath Racing Cylinder guard
Renthal Bars
TM Designs Guide and Slide
Custom seat cover by Cosmic Quads
Controls:
RTC Levers
Moose throttle
Spider Grips
Powermadd hand guards
Pro Design Shorty shifter
Pro Design kill switch
Denton Stabilizer
Engine:
New case halves
New Crank
All new bearings and seals
New clutch with 89 update
Lightened Flywheel
ESR 265 PV Cylinder w/Midrange port
Sparks TT Pipe and Silencer
Billet Exhaust Flange
Billet Case Saver
Boyesen Reed Cage
38mm AS Carb
K&N Filter