can't decide on cams

[honda450runicam]

I need some feedback from you guys on this subject. I know it's getting to be like beating a dead horse around here.

My setup right now is a crf cam, crf carb, sparks exhaust, 13.1 piston, open airbox, head is cleaned up but..... I want more power

Cams considering....

hotcam stage II
hotcam stage III
web camshaft 493/729

Any suggestions, feedback or expirence is greatly appericated.

Thanks.

[Flyin-Low]

Alright, hotcam stg. 3 is a stroker cam..

Hotcam stg. 2 is a GREAT cam, it's what I run and is completely drop-in.

From what I've heard the webcam is good too, but I'm not sure if it req. hardened rockers or not?

-Martin

[d3ktrix]

What year is ur CRF cam? 02? 05?

If u want more power then what you have now, I'd say ur next step is head work.

Different cam isn't going to give you much more power, just in a different place.
Unless u get that crazy web cam that requires u to sawsall ur entire top end to make it fit. lol

[tooanxiousii]

I went from a HC2 to a web mysto cam and gained 5 hp but it's not cheap to put a large cam in you need shorted valve guides, HD valve springs, Adjustable cam gear then you need to degree your cam so you have vavle to piston clearance..

[Chino886]

You said you had your head cleaned up, who did the work? If it is a shop, ask them what cam selection you should try, some porters have port jobs that work better with cam A rather than cam B.

[mrnate400ex]

i have the web 943/921 cam and it pulls really hard almost clear to the top. it is a low to mid cam but runs really well. i pulled 45.07 hp running 6 jet sizes to lean on top. i changed my jet but didn't run it again. i figure i'm at 47-48 pretty easily. i'm running a '07 with a full dasa exhaust and that cam. i love it!!!