maxamillion
04-16-2007, 06:45 PM
I bought one used lower 2000 model 400ex stock a-arm to use on a 2001 400ex I have. Are the lower ball joint stud diameter (the tapered part) the same on the 2000 and 2001 model?
I installed it and the balljoint goes to far up into the spindel. When I put the nut on to tighten it, I run out of thread way before its tight. So then I put washers in there to take up the space, and now the rubber boot is binding with the spindel because its to far up and rubbing. Its makes it alot harder to turn now.
Does anyone have an idea if the diff years have diff diameters?? Thanks!
I installed it and the balljoint goes to far up into the spindel. When I put the nut on to tighten it, I run out of thread way before its tight. So then I put washers in there to take up the space, and now the rubber boot is binding with the spindel because its to far up and rubbing. Its makes it alot harder to turn now.
Does anyone have an idea if the diff years have diff diameters?? Thanks!