Barrymaxx
04-13-2007, 03:08 PM
I have a 99ex that im rebuilding. I have the topend off, the clutch ocer off, and all the gears and components under the cover off. I have the motor up on the bench.
I just washed out the whole lowerend with some gas. Then I was oiling up all the bearings when I noticed something. When I spin the crankshaft, it can turn inside the bearing race. There is a tad bit of slop, I mean maybe a .0001 or less. The bearing feels like new and is smooth.
Is the inner race allowed to rotate on the crank, or should it be a press fit?
I just washed out the whole lowerend with some gas. Then I was oiling up all the bearings when I noticed something. When I spin the crankshaft, it can turn inside the bearing race. There is a tad bit of slop, I mean maybe a .0001 or less. The bearing feels like new and is smooth.
Is the inner race allowed to rotate on the crank, or should it be a press fit?