View Full Version : what color a arms????????
sportrax stu
04-10-2007, 04:11 PM
i have a 03 400ex with red plastics and i have just bought a set of 450r shocks, i thought i might as well get the a arms powder coated cos they are a bit chipped. what color do you think would look best? black, red, blue ect
any help would be appreciated
rescue6
04-10-2007, 04:29 PM
If they are stock A-arms you will not be able to powder coat them you will have to paint them. Red or Black
sportrax stu
04-10-2007, 04:35 PM
yes they are stock a arms, why couldnt i get them powdercoated:ermm:
Honda#4
04-10-2007, 04:54 PM
Cus the ball joints are non removeable.
sportrax stu
04-10-2007, 05:01 PM
what type of paint would work well? would i have to rub it down first? and prime it?
thanks
sportrax stu
04-10-2007, 05:09 PM
bump lol
Honda#4
04-10-2007, 05:18 PM
If you have acess to a sandblaster use that to get the paint off if not then you'll have to sand them, as for the painting make sure you put on plenty of clearcoats.
When I paint I just use any automotive paint, don't buy the cheap stuff otherwise you end up with cheap results.
Hope this helps ya out.
sportrax stu
04-10-2007, 05:25 PM
would a car shop sell clear coat paint? also do you use a spray can? whats the best type of sand paper to use?
thank you
Honda#4
04-10-2007, 05:42 PM
Yea a car shop should sell it I think, or just go to Wal-mart and buy some, that's where I buy my paint from and it works great. The paint comes in a spray can most people call it rattle can paint.
For sandpaper use like 60 grit it's the real course stuff.
sportrax stu
04-10-2007, 06:02 PM
i live in the u.k and i don't know what a wall mart is lol. is it like a DIY store?
thanks for being so helpful
Honda#4
04-10-2007, 06:39 PM
O, I guess I did'nt look at where you live. Yea its kind of like that in a way, but a car shop would have it or just a paint store carries spray paint also so check there.
rescue6
04-10-2007, 07:24 PM
You will need to clean the surface up real well and use a 180 grit to start and go to about a 600 grit paper in incriments if you want a good smooth looking paint job and yes use a primer first and then a clear over the paint . 60 grit is way to coarse and usualy only used on wood or other soft materials.
Honda#4
04-10-2007, 07:33 PM
Yea rescue is right!
sportrax stu
04-11-2007, 02:12 AM
thanks rescue 6. how do i apply the clear coat? i mean to i put a layer on of paint and then a clear coat? what should be my final coat? clear or paint? and finally how many layers would you reccommend?
thanks again
Honda#4
04-11-2007, 07:25 AM
When I paint I do 3 coats primer, 3 coats paint, and 4 coats of clearcoat.
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.