Rear axel bearing

[daiglea]

I am thinking of doing some on my rear Axel and was wondering if it is easy to change the bearings on the rear stock axel.. If so does anyone have a scema on what needs to be taken apart?

Thanks all for the quick reponses ive gotten over the last few post here. YOU ROCK!!!:devil

[YZROOSTINYA]

put the carrier i the oven when you get the axle out. the aluminum heats faster then the bearing and the bearings will fall out when you tap it. take the seals out first too.

go to servicehonda.com and look up the blow parts fische of the axle to see what comes apart. its not hard

[Extremeracer167]

The only trick i know is, take a pipe that just fits inside the inner race of the bearing, and put a few spot welds on the bearing to the pipe. Then u just gotta kind of beat it out. The only thing u ahve in the carrier is the 2 seals, 2 bearings, and the sleeve. bearing and seal on each side, and the sleeve in the middle....piece of cake