4moretoyz
03-27-2007, 08:27 PM
Hi All:
I am replacing the bearing and seals on my wifes 2001 Scrammy 400 2x4 water pump, when I took off WP impeller it had what appears to be an extra small flat washer behind the impeller that does not show up on the schematics. This was last rebuilt by a shop, I have the reciept. is this some trick, cuz I can't tell if the back of the impeller rubs on the WP case without it, cuz it's all enclosed when I put it back together. All the local shops are totally clueless, maybe that's why it's in there, any help? Thanks much in advance.
I am replacing the bearing and seals on my wifes 2001 Scrammy 400 2x4 water pump, when I took off WP impeller it had what appears to be an extra small flat washer behind the impeller that does not show up on the schematics. This was last rebuilt by a shop, I have the reciept. is this some trick, cuz I can't tell if the back of the impeller rubs on the WP case without it, cuz it's all enclosed when I put it back together. All the local shops are totally clueless, maybe that's why it's in there, any help? Thanks much in advance.