Aaen Intake kit for Outlaw 500...

[Dastump]

Anyone had experience with this product, was looking to see what people thought about putting this intake with HMF Bill Ballance Pro series full exhaust, and what jetting you think will need to be done?

Thanks for any advice,
E.Z.

Kit located here...

http://www.aaenperformance.com/Power_Pipes.asp (http://)

[X_Da_C]

I have it. its been great, and surprisingly that little pan keeps a lot of the water out.

[katch26]

the quality of this kit is really poor.

[Dastump]

Can you elaborate? I guess I will have to test it for myself as its already ordered heh. You think I would be better off just using K&N with outerwear and no lid or something? only reason I went with this one Is there is not much out there to find for the outlaw, or atleast that I have found. If you have any other recommendations I am all ears.

Thanks again,
E.Z.

[katch26]

http://www.predatorowners.com/index.cfm?action=thread&catid=99&topid=435&thrid=26281

[X_Da_C]

All it is is a cut piece of metal with a k&n filter lol

[katch26]

exactly....and the metal is cut poorly to boot

[Dastump]

Ya... pretty disappointed in it.... installed it and my pipe....went for one ride to check jetting and it blew off. It is cheaply made for the price they charge. Live and learn I guess, because I bet they will not take it back heh. Ended up using stock box with lid off and a K&N filter and outerwears prefilter and the full HMF exhaust. It's pulling pretty good with a 165 main jet, and slight adjustment to the air mix screw. One question, when yall hit rev limiter are yall getting some popping? I'm assuming that is normal. Thanks again for the responses.

E.Z.

ps. Also... with that setup do you think I can go up to a 170 jet? or would i need a bit more air flow for that. Thanks again.

[katch26]

hitting the rev limiter and being lean/rich will feel about the same. I run a 172.5 main ion mine...in md