RAD tapered bearing carrier..400ex/250r

[Glamis400ex]

Used but excellent condition RAD tapered bearing carrier. Comes with everything seen. Dust seals MAY need replacing...not sure.

$175

Glamis

[Glamis400ex]

bump

[Glamis400ex]

bump...$

[noreversesucks]

Any idea what the inside diameter of the bearings is?

[Glamis400ex]

I'd venture a guess and say it's the same as the outside diameter of your axle...why do you ask?

[noreversesucks]

Originally posted by Glamis400ex
I'd venture a guess and say it's the same as the outside diameter of your axle...why do you ask?

Hahaha, good answer!

But....I don't have a 400ex or 250r....

On the other hand I do have an Alba swingarm for my Raptor that uses a round carrier and I'd like to have a tapered bearing carrier for it.

Now ya see what I'm getting at? :devil: :D :D

[Glamis400ex]

Yah, OK, you might want to find out if it'll work for you. If you have the round housing style swinger/carrier, I'm gonna bet you can use this. You'll need to run a 400ex rear caliper.

[noreversesucks]

Originally posted by Glamis400ex
Yah, OK, you might want to find out if it'll work for you. If you have the round housing style swinger/carrier, I'm gonna bet you can use this. You'll need to run a 400ex rear caliper.

Caliper won't be a problem. I'm using a CR250 dirtbike , (or CRF250?), front dual piston caliper! LOL

I'l do some lookin around and see what I can find out.
Thanks.

[noreversesucks]

Originally posted by Glamis400ex
Yah, OK, you might want to find out if it'll work for you. If you have the round housing style swinger/carrier, I'm gonna bet you can use this. You'll need to run a 400ex rear caliper.

Caliper won't be a problem. I'm using a CR250 dirtbike , (or CRF250?), front dual piston caliper! LOL

I'l do some lookin around and see what I can find out.
Thanks.

[Glamis400ex]

bump $160

[Glamis400ex]

bump/offers??

[noreversesucks]

I've been looking around and 400EX/250r use a 40mm ID bearing and my Raptor uses a 35mm ID bearing, so I'd have to get a new bearing set for it.

Even then I'm not sure about if the bearing placement, (side to side and distance between them), would be the same.

I guess I'd better pass. :(
Good luck.

[Glamis400ex]

no worries...glad you did your homework and found out.

[noreversesucks]

Originally posted by Glamis400ex
no worries...glad you did your homework and found out.

I'm gonna email Rad and ask them if it would work if I cahnged the bearing. I'm not given up yet! LOL

[Glamis400ex]

I was in touch with them a week or so ago. They are very helpful. They will be able to help you for sure.

[Glamis400ex]

bump..can't believe no one wants this tapered carrier for the price of a double row.

[Glamis400ex]

bump...$150