bakerboyz
10-07-2002, 02:29 PM
I took apart my 300ex axle and carrier to change the bearings and inspect/clean the rest. A few of the o-rings were destoyed and I'm looking through the manual and parts diagrams and am a little confused.
How many O-rings do I need? From left to right I figure the following
1 on the axle next to the sproket holder
2 on the outer of the bearing holder
1 on the left of the carrier (smaller than the 2)
1 on the axle before the brake disk hub
1 in the brake caliper holder
That's a total of six. Does this sound correct?
Thanks
How many O-rings do I need? From left to right I figure the following
1 on the axle next to the sproket holder
2 on the outer of the bearing holder
1 on the left of the carrier (smaller than the 2)
1 on the axle before the brake disk hub
1 in the brake caliper holder
That's a total of six. Does this sound correct?
Thanks