Question about bars...Need advice!

[wicked13]

I am running a Roll Design +1 stem with "regular" size ATV bend bars (TAG with crossbar). They are too high for me, so I ordered a new set of IMS CR-Hi bend ATV bars (no cross bar). IMS said that they will be lower than what I have by around an inch, but I havent seen any to compare them to. Can anyone give me some input???

I know they require the bigger bar clamp. I ordered that too. lol

[NacsMXer]

CR Highs are going to be very low in comparison to the ATV bend bars. You will like them however since you have a +1 length stem. CR Highs are low, wide, and straight in terms of the sweep back..they have a very nice feel to them. I see you also stepped up to a 1 1/8" taper bar which is a nice upgrade over standard 7/8" bars. Since there's no cross bar on the tapered bars, they have more downward flex to them to absorb the hard hits instead of jarring you like standard bars can. They are also much stronger in comparison, much harder to bend them.