PDA

View Full Version : Duncan Pc2000 265 Powervalve



doc-bones
03-17-2007, 09:57 PM
This is one of Duncan`s top end kits. They have been making them for awhile, and updated the cylinder a couple of years ago. This is one of the newer updated versions. This cylinder has had extra port work and polishing and re nikasil coated recently. Basically it is like new and better than new! Included is a like new just broken in 68mm wiesco piston with clearances set at .0025, new 21cc dome included. Requiring 100 octane gas. A 19cc dome would be needed if you were wanting to run straight race fuel. This kit sells for $1800. from Duncan and is the best made! This will beat the new 4 strokes with no problems!

Motor was broken in nice and slow, completeing many heat cycles before running hard. Several idle sessions in driveway, several short rides, and periodically increased time and aggressiveness to break in well.

This makes strong power throughout the powerband!!

This is priced to sell quickly.

$799.00 shipped

I also have a DUNCAN PJ37 Carb with new cable $115. shipped

doc-bones
03-17-2007, 10:00 PM
This is the BEST money can buy!

doc-bones
03-19-2007, 03:10 PM
This is the best cylinder out there...............

doc-bones
03-20-2007, 08:43 AM
Inside Cyl pics!

doc-bones
03-21-2007, 04:00 PM
This is a Smokin set-up. Do not miss out! This set-up would cost $2,500. from Duncan Racing.

800screws
03-21-2007, 07:21 PM
u don't happen to have a lowerend to bolt this on for sale also?

doc-bones
03-21-2007, 07:33 PM
Actually, I do. Right now I have a 88 bottom end with newer clutches. All in great condition. I would sell bottom end which needs nothing as it is on my Roll Design right now!
I would sell complete: Duncan Powervalve, Duncan Carb, Duncan/Paul Turner pipe, Reeds and complete 88 bottom end. Clutch cover included. No ignition cover or Stator.
$2,100. Shipped

doc-bones
03-22-2007, 02:33 PM
Pics of bottom end

doc-bones
03-22-2007, 02:34 PM
one more

doc-bones
03-22-2007, 02:37 PM
Port work. You can see how new.... Still see cross hatches!

doc-bones
03-22-2007, 02:39 PM
Cylinder

800screws
03-22-2007, 06:34 PM
ok, i have to ditch my 426 setup from my hybrid, and i will give u a shout!

doc-bones
04-03-2007, 06:48 AM
SOLD to LathersR............ PENDING FUNDS!
Thanks,
Doc