Hot Cam

[markvette]

i see hot cams has a cam for the 300ex now. has anyone tried this cam yet. you dont have to pay a core charge and it dont say you have to change to hardened rockers.

Mark

[2muchquad]

Yeah i would like to know myself,i doubt i will get one though as i have a web cam and a sparks cam already for mine.I am a bit curious though as far as the specs...

[Pappy]

anyone find anything out on this?

[300ex_#387]

I'm currently getting one put in mine right now. I should have the motor back next week and I will let you guys know how it runs. We also got it bored to to a true 300, ported, and put on a 400ex carburator.

[Lonestar_R]

I have one on order from C&D right now. I will probably be doing a stock bore 11:1 compression piston stock head no porting, stock rockers and springs, and a stock carb, with a White Brothers Full exhaust and a Twin Air Filter. So it will be a pretty basic setup. So we will see how she runs. I think it will be a great drop in cam for a little more zip on the little old 300

[2muchquad]

I will probably be doing a stock bore 11:1 compression piston stock head no porting, stock rockers and springs, and a stock carb, with a White Brothers Full exhaust and a Twin Air Filter. So it will be a pretty basic setup


Dont be surprised to see how good it runs.I had the almost same basic setup while i was building my other motor and with just a 11to 1 wiseco and a 400ex carb with a exhaust system i was doing all kinds of crazy things on that quad.At 6ft 1 215lbs and 34yrs of age,im not your typical 300ex rider.It runs badazz for a "kids quad":D

[Lonestar_R]

then my stepson ought to have a ball on this thing.......it'll have a +2 Laeger swinger and +2 burguard a arms. She should Rip

[markvette]

here are the specs off hot cams web site.


Intake
Intake lift (mm): 7.5
Intake lobe center (degrees): 103.5
Intake duration (degrees at 1mm): 238
Intake valve lash (mm): .10
Exhaust
Exhaust lift (mm): 7.5
Exhaust lobe center (degrees): 103.5
Exhaust duration (degrees at 1mm): 232
Exhaust valve lash (mm): .15
Note: Divide mm values by 25.4 for inch

[2muchquad]

Yeah those look like numbers from a "torque cam".Im sure it will have more mid than stock though.