jets ,which one

[sparta4188]

i have a 96 wolverine 350 4x4, i am getting a HMF slip on, and a kn air filter , what jets should i use from http://www.jetsrus.com/main_page.htm
? thanks my elevation is under 1500

[sparta4188]

i'll be riding in the summer around like 70 degrees now it's like 10 degrees

[sparta4188]

bump

[GPracer2500]

I know nothing about Wolverines. Have you asked HMF for a recomendation? If they give you one that might be a good starting point. But don't expect it to be spot-on right off the bat.

If all else fails, just go up 3 or 4 jet sizes and see how it runs. To a certain extent jetting is matter of trial and error......make a change, then test.....make a change, then test.....etc.

[sparta4188]

thanks i'll ask them

[rooster300ex]

Yea I had to trial and error my jetting and finally found out where it ran the best. Just get 3-5 jets that are larger and try it. Then set your air/fuel screw the correct way, and if its not running right at half throttle you need to mess with the needle setting if you can.

this site was very helpful to me.
http://www.motorcyclecruiser.com/tech/motorcycle_jet_kits_carburetion/