Architects
03-08-2007, 01:25 PM
Time to start assembling all the parts I've gathered. Riding style is MX only.
Jd +3 St a-arms
RPM dominator
Derisi Revalved shocks
Streamline braided lines
Woodward twin row bearing carrier
Woodward stainless steel swinger bolt
Pivot works swinger rebuild kit
Rad L2 lock-nut
1. As far as toe goes. Should I have toe-in/toe-out/or no toe at all?
2. What kind of camber should I run. How do I go about measuring this?
3. For caster there are shims on the JD arms? I know there is an MX setting for these. Anyone know it?
4. What kind of grease should I use on my bearing carrier,Swinger bolt, and swinger rebuild kit.
5. Does anyone have any pointers on axle installation. Pics or procedures? Torque specs?
6. Anything to look out for in general? I'm trying to make this as painless as possible.
Jd +3 St a-arms
RPM dominator
Derisi Revalved shocks
Streamline braided lines
Woodward twin row bearing carrier
Woodward stainless steel swinger bolt
Pivot works swinger rebuild kit
Rad L2 lock-nut
1. As far as toe goes. Should I have toe-in/toe-out/or no toe at all?
2. What kind of camber should I run. How do I go about measuring this?
3. For caster there are shims on the JD arms? I know there is an MX setting for these. Anyone know it?
4. What kind of grease should I use on my bearing carrier,Swinger bolt, and swinger rebuild kit.
5. Does anyone have any pointers on axle installation. Pics or procedures? Torque specs?
6. Anything to look out for in general? I'm trying to make this as painless as possible.