motx349
03-03-2007, 09:15 PM
The modifications to the 4 wheeler include :1999
440 Big Bore Kit, with a new cylinder and thumper piston 11/1 (made by Wisco) in 06
replaced the 8mm cyl. studs with 10mm.....
last year put in a new hot cam stage 2
basically last year rebuild the bike motor for top to bottom lots of low end power....
will run on 87-93 gas but i'm right now running Cam 2
stock carb.
K/N filter with outerwear cover
new last year 4.2 gal. gas tank.
chain and sprocket fairly new,appox 1 year of riding on them still in good shape
White Brothers E-Series Full exhaust system, brand new slip on last year, full header pipe
OMF Race Rims,with XC holeshots on the front and HD holeshots on the rear
Elka Triple Rate front shocks,with shock covers
Denton Rebuildable Steering Stabilizer.
full belly to rear skid plate
A-arm guards not on bike at this time
Moose brush guards
lsracing tie rods
extra set of yellow front and rear plastic GC
extra set of Kenda Klaws fronts on 190 rims
extra set of 22x11x9 Kenda Bear Klaws on 190 rims
extra set of 20x11 holeshots not on rims.
axle is stock.
after market rear grab bar
A-arms are stock but have grease fittings and new ends put on them.....something a little different......
normal wear and tear.....rear plastic has some zip ties near the rear grab bar and the normal burn mark near pipe.
can email pics, do not know how to post
quads in va.
$2900
thanks,
Matt
440 Big Bore Kit, with a new cylinder and thumper piston 11/1 (made by Wisco) in 06
replaced the 8mm cyl. studs with 10mm.....
last year put in a new hot cam stage 2
basically last year rebuild the bike motor for top to bottom lots of low end power....
will run on 87-93 gas but i'm right now running Cam 2
stock carb.
K/N filter with outerwear cover
new last year 4.2 gal. gas tank.
chain and sprocket fairly new,appox 1 year of riding on them still in good shape
White Brothers E-Series Full exhaust system, brand new slip on last year, full header pipe
OMF Race Rims,with XC holeshots on the front and HD holeshots on the rear
Elka Triple Rate front shocks,with shock covers
Denton Rebuildable Steering Stabilizer.
full belly to rear skid plate
A-arm guards not on bike at this time
Moose brush guards
lsracing tie rods
extra set of yellow front and rear plastic GC
extra set of Kenda Klaws fronts on 190 rims
extra set of 22x11x9 Kenda Bear Klaws on 190 rims
extra set of 20x11 holeshots not on rims.
axle is stock.
after market rear grab bar
A-arms are stock but have grease fittings and new ends put on them.....something a little different......
normal wear and tear.....rear plastic has some zip ties near the rear grab bar and the normal burn mark near pipe.
can email pics, do not know how to post
quads in va.
$2900
thanks,
Matt