CDALEMX301
03-01-2007, 11:02 AM
Alright it has come to that time where I am more in the need for money then for the Cannondale. I crashed in May of last year and have only rode it 4 times since then. In April of 2006 I installed a new piston and sleeve, new timing chain, and new clutch plates and springs. Never had any mechanical problems with the bike if I remember correctly it was dynoed on 10/11/2001. Single owner, clear title
ATV has had the oil changed with Spectro oil every three rides. Valve clearance was checked when piston/sleeve were installed and was within spec. Crank Plate and Tranny studs were checked and not loose. Motor is early type with cable clutch. Quad includes D&M Kit for laptop and IPaq and also many stock parts.
Chassis Component upgrades include:
+2 LSR Std travel front end w/ Comp adjust Elkas valved for 165 pound B Class MX
LSR Std length Steering stem (2 rides bought in Aug. 06)
LSR Adj. Axle
Denton Rebuildable Steering Dampner
Tag T-2 CR Double Hi handlebars
Graydon Proline Std Nerf Bars
Blingstar Bumper
OMF Rad. Shrouds
Kenda Klaws mounted on .190 ITP Baja Wheels w/ reinforced rings
Engine Components:
Aluminum Impellar
Magnesium Valve Cover replaced Fall of '05
New Timing Chain 4/2006
New Piston/Sleeve combo 4/2006
Clutch replaced 4/2006
HMF exhaust
ATV is in excellent mechanical condition starts everytime and runs fine, Visually Quad is very clean blingstar bumper is slightly bent and handlebars have a very slight but very rideable bend on the right side. New Tie-rods are in the mail and steering stem and brake lever were replaced after crash. Plastic has a few scuffs and a couple cracks about 1/2 inch long.
Pictures are pre-crash so bent bumper is not in this pic. willing to replace bumper with serious buyer. Seat foam has also been shaved...
http://i10.photobucket.com/albums/a109/fieldymx301/CannondaleSept26002.jpg
http://i10.photobucket.com/albums/a109/fieldymx301/CannondaleSept26003.jpg
http://i10.photobucket.com/albums/a109/fieldymx301/CannondaleSept26004.jpg
Looking to get $3500 out of her ATV is located in Central, Massachusetts. You can contact me at mfield1@worcester.edu or on my cell 617-548-9843 ask for Mike
ATV has had the oil changed with Spectro oil every three rides. Valve clearance was checked when piston/sleeve were installed and was within spec. Crank Plate and Tranny studs were checked and not loose. Motor is early type with cable clutch. Quad includes D&M Kit for laptop and IPaq and also many stock parts.
Chassis Component upgrades include:
+2 LSR Std travel front end w/ Comp adjust Elkas valved for 165 pound B Class MX
LSR Std length Steering stem (2 rides bought in Aug. 06)
LSR Adj. Axle
Denton Rebuildable Steering Dampner
Tag T-2 CR Double Hi handlebars
Graydon Proline Std Nerf Bars
Blingstar Bumper
OMF Rad. Shrouds
Kenda Klaws mounted on .190 ITP Baja Wheels w/ reinforced rings
Engine Components:
Aluminum Impellar
Magnesium Valve Cover replaced Fall of '05
New Timing Chain 4/2006
New Piston/Sleeve combo 4/2006
Clutch replaced 4/2006
HMF exhaust
ATV is in excellent mechanical condition starts everytime and runs fine, Visually Quad is very clean blingstar bumper is slightly bent and handlebars have a very slight but very rideable bend on the right side. New Tie-rods are in the mail and steering stem and brake lever were replaced after crash. Plastic has a few scuffs and a couple cracks about 1/2 inch long.
Pictures are pre-crash so bent bumper is not in this pic. willing to replace bumper with serious buyer. Seat foam has also been shaved...
http://i10.photobucket.com/albums/a109/fieldymx301/CannondaleSept26002.jpg
http://i10.photobucket.com/albums/a109/fieldymx301/CannondaleSept26003.jpg
http://i10.photobucket.com/albums/a109/fieldymx301/CannondaleSept26004.jpg
Looking to get $3500 out of her ATV is located in Central, Massachusetts. You can contact me at mfield1@worcester.edu or on my cell 617-548-9843 ask for Mike