JDMThoughts
02-25-2007, 01:39 PM
I just installed new sprockets and chain due to a few teeth broke off the rear last weekend during a ride. The chain slack was awful so I went ahead and geared the quad back down from the previous owner's 16/38. I am now back to a 15/38 using Sunstar sprockets and a new D.I.D. ATV O-Ring chain. I got everything back into order and adjusted the axle to get the tension and slack I desired. Which turned out to be 1 3/16" Which is a little tighter than the manual wanted but was looser than the manufacturer's suggested of 1 1/8". I rode around and took it easy and then went to my regular spot and rode a lot no problems. I am going to give a friend a lift back to his house on the back since it began to hail and halfway home the chain threw itself off again. No messed up teeth or anything but I was surprised. I just checked it again and everything seems alright. I am just unsure of what I should go and do now. I don't wanna buy another chain if I messed this up. I am wondering if I forgot a step or something. Also, I left the wax on and did not apply any chain lube. I have a fresh can of chain lube and was wondering should I apply it before my next ride to get a nice coat on it. Thanks for the help guys.