Blowing fuses!!

[asjr39]

I have the PRO ARMOR kill switch. I wired one line the the solid orange line under the front fender the second I tried to ground it on a bolt connected to the frame and I continue to blow fuses whats the deal???

[bbrad mulvey]

I had the same problem also! I ended up having to go to the white wire back by the fuel pump and then I grounded the other wire. But I kept blowing fuses too. I even tried to up the fuze size and it kinda worked. But do the white wire by the fuel pump;)

[asjr39]

Wheres the fuel pump located? can I get to it from the under the front fender? and where is a good place to ground it?

[Baracudaaa]

Try wiring it into the tip over switch, easy to do and I have never poped a fuse.

[asjr39]

What the hell is the tip over switch?

[AL Elks]

Uh Oh!

A manual is your friend.

It's a switch that turns off the fuel pump/quad if it tips over. You actually have to turn the quad off and then back on to reset it.

AL

[asjr39]

I dont have a manual. So can you tell me where its at or what wires to connect too. orange(solid) orange(white stripe) theres only two wires. Ive made cuts in both wires and im still blowing fuses.

[bbrad mulvey]

Do a search on here and it will walk you right through the correct way to wire it in. But the fuel pump is right by your left knee when you are sitting down. Its kinda a goffy lookin cylinder shape right where the rear plastic and the front plastic meet. So directly above your footpeg on the left side;)