Putting on graphics?

[blastinroost]

Any tips/tricks? What about getting bubbles out?:D

[400EXtreme]

make sure that its really clean.

[DOHC]

heat guns help

[WHITE SEAT]

Spray a mist of water on your plastic before you put your graphics on.

[nowukno]

1. clean plastics very well with soap/water
2. use fine grit sand paper to work out some scracthes/scuffs
3. rub plastics down with rubbing alcohol
4. mist water on back of decal for easier placement
5. use window tint squeege for any air bubbles
6. use blow dryer/heat gun to dry but don't use too excessively

These are the steps i followed and mine are holding up great so far.

Oh yeah , the biggest tip you can have is........

Take your time and don't get frustrated.