PDA

View Full Version : Pivot Bolt


Caseys 300ex
02-14-2007, 02:05 PM
Well im tearing down my 300ex for a rebuild and my pivot bolt wont come out. How do i get this thing out?
XCAdam89
02-14-2007, 02:14 PM
With a mallet and a few choice words. On the contrary, after you get it out, I suggest sending it to Pappy to be molycoated. It will ultimately make your life easier in the end. :p
Caseys 300ex
02-14-2007, 03:33 PM
Well i cant get the nut off of the bolt. What size sprocket do i need for that nut?
Sjorge450R
02-14-2007, 07:34 PM
Originally posted by Caseys 300ex
Well i cant get the nut off of the bolt. What size sprocket do i need for that nut?

hey I have a BRAND NEW bolt and nut. You are prob going to have to destroy that one getting out. this is a $60+ part. Let me know if you want it.

Oh and i think the nut is 22mm.
tw62t
02-14-2007, 07:54 PM
Try using a propane torch and heat the nut up to loosen. It will probably ruin the locknut but its better than messing up the bolt.
Caseys 300ex
02-15-2007, 03:42 PM
Originally posted by Sjorge300EX
hey I have a BRAND NEW bolt and nut. You are prob going to have to destroy that one getting out. this is a $60+ part. Let me know if you want it.

Oh and i think the nut is 22mm.

How much you looking to sell it for?
Sjorge450R
02-15-2007, 04:01 PM
Originally posted by Caseys 300ex
How much you looking to sell it for?

45 shipped?