nowukno
01-31-2007, 07:19 AM
Just wanted to make sure i got this right before i install them. BTW they are quadfast graphics .........
1. drain tank , let air dry
2. clean plastics very well with soap/water
3. use fine grit sand paper to work out some scracthes/scuffs
4. rub plastics down with rubbing alcohol
5. mist water on back of decal for easier placement
6. use window tint squeege for any air bubbles
7. use blow dryer to dry
Am i forgeting anything?
1. drain tank , let air dry
2. clean plastics very well with soap/water
3. use fine grit sand paper to work out some scracthes/scuffs
4. rub plastics down with rubbing alcohol
5. mist water on back of decal for easier placement
6. use window tint squeege for any air bubbles
7. use blow dryer to dry
Am i forgeting anything?