Clutch bolts

[beaker1214]

Any one have any idea about what torque that the five bolts on the clutch should be set at? I have already broke a bolt inside the hub so I'm on my second hub and don't want to screw it up again. Any help would be great, thanks!

[interceptorz28]

Use a 1/4" socket wrench and just snug it up. Sorry, i dont have the torque specs.

[beaker1214]

no that works completly I just didnt know how tight they needed to be thanks

[NacsMXer]

Originally posted by interceptorz28
Use a 1/4" socket wrench and just snug it up. Sorry, i dont have the torque specs.

He's right, just snug them down in a criss cross pattern in several steps. There is actually no torque value, just be careful no to snap them off, i've seen it done :p

[beaker1214]

yeah hahah I already snapped one the first time thats what im worried about

[NacsMXer]

Oh lol, I didn't read your post too well, I just quickly glanced over it :blah:

....but yeah, make those bolts snug but not insanely tight. You don't have to worry about them coming loose on you since they are under spring pressure. Better to be a little too loose then too tight and snap them......as you are aware haha :p

[zrpilot]

Originally posted by beaker1214
yeah hahah I already snapped one the first time thats what im worried about

I did the EXACT same thing... so don't feel bad. I was able to back my broken screw out of the hole and still use the basket, which is good cause it is a GT Thunder modified inner pressure plate that would have cost more and delay my build...

good luck