Clutch adjustment

[zack221]

I can not adjust my clutch on my cr125 it works good while the dirtbikes running.But when it is turned off if i pull it in and try to roll it back it acts like i dont have in the clutch and it catches.I have adjusted it all the way in and out but it does not help.Is it time to get new clutch plates?The clutch works good while the dirtbikes running i can pull it in and it dont try to take off.But when it isnt running it wont roll when i pull in the clutch.

[firefighterjosh]

My banshee would do that too. Not sure what the problem was but It did it for 2 years and I never ran into problems:p

[zack221]

So you didnt have any problems with it?

[blasterfreak99]

hey dude, it should be fine. it did it when i had it, the blaster does it, that kx 60 does it, and my bros 250x does it. i think it is where the clutch plates are not warmed up or it is where the engine isn't turning the plates and they don't get any gear lube so they stick together. but i could be wrong.