bearing

[number5]

I have to change front wheel bearings in a lonestar hub. Im having a hard time getting them out. I sprayed pb blaster on them last night. Going to see how that works out tonight. I bent a screw driver tip over so it could catch the lip on the bearing on the other side but it keeps slipping off the lip. Any suggestions?

[Creech52]

This may be a long shot, but in theory it works. Go to your local autozone, rent yourself a pilot bushing remover and a slide hammer, hold the hub down some how, insert the bushing remover tighten, and slide hammer that son-B!. Make sure you check the fingers on the remover before leaving the store, alot of them are worn down and dont have much of a lip on them anymore.