Wheel Spacers

[300ex03_619]

How are wheel spacers? Durability? Quality? Worth it or not?

[CRich[814]]

they suck. they wear stuff out very fast. but there fine if you dont jump.

[300ex03_619]

well i race mx....so bad idea?

[CRich[814]]

haha absolutely. they wear out tie rod ends very quickly. just unneed pressure on the front end. same thing with going with a huge offset rim. what do you race? i thought you have a kx190?

[300ex03_619]

i do, im looking into a banshee.....see long story short, used to raxe 300ex in mx, kicked *** at it, broke a crankcase traded it to a sucker for this kx and now lookin to race mx again!

[KingpinsEx]

Im not sure about running them on the fronts, but i have run them on the rear for a full race season of mx on my 400 and never had a problem...Of course thats not to say you wont have problems, the one's i used were custom made out of aluminum and i repalced the spindles with Grade 8 bolts for extra strength.

Your best off going this way in my mind. Buying the a-arms and using spacers on the rear until you can afford an axle...I know its not the best method but if your a racer on a budget they make the world of difference on the track when you can't afford an extended axle.

[300ex03_619]

that bolt idea is a great idea, i think i have a trade for a quadzilla lined up, do u know any way to make them work on the front and not be destructive? Becaus ei am BROKE