660LE
01-15-2007, 07:16 AM
When i replaced the crank bearings and put the two halves of the motor together and torqued it all to spec. Put the flywheel on. I try to turn the crank by hand and its very stiff. But if i put a wrench on the flywheel nut i can turn it. Is this just the bearings needing to be broken in. or is something not right. I knwo on my yfz when i replaced the bearings i coudl turn the crank with no problem. Maybe i didnt press the bearings in the case's far enough and its binding up? Thanks.