ralph2
01-11-2007, 02:16 PM
i am planning on doin alittle rebuild while i can... anyway i wanted to do a cam, piston, valve and clutch upgrade. im on a low budget so that narrows some things down, but my main concern is if i can use any combination of things. for example... i already have an hrc cam waiting for me to put in. now will this cam work with any high compression piston? or do i have to get a piston and cam combo? also is the hrc cam a good choose for mx?
on to the piston...
i wanted to upgrade to a slighly high compression without sacrificing reliability. i was thinking about going with a 12.0 :1 JE. from what i understand that is about the limit before switching to race gas. let me know what you think about that choose, and again will this piston work with any cam? hrc cam?
valves...
i have read that the titanium valves are more or less a waste of money since they are very expensive so i have put those out of the picture. what stainless valves are the best, and should i be going oversized on both exhaust and intake? or not at all?
clutch...
again i am looking to keep the cost down so i was thinking about going with a hinson clutch. plates, steels, and springs. i understand that the oem clutch is suppose to be the best but will the hinson be suitable?
any information on all this would be more then helpful
on to the piston...
i wanted to upgrade to a slighly high compression without sacrificing reliability. i was thinking about going with a 12.0 :1 JE. from what i understand that is about the limit before switching to race gas. let me know what you think about that choose, and again will this piston work with any cam? hrc cam?
valves...
i have read that the titanium valves are more or less a waste of money since they are very expensive so i have put those out of the picture. what stainless valves are the best, and should i be going oversized on both exhaust and intake? or not at all?
clutch...
again i am looking to keep the cost down so i was thinking about going with a hinson clutch. plates, steels, and springs. i understand that the oem clutch is suppose to be the best but will the hinson be suitable?
any information on all this would be more then helpful