PDA

View Full Version : help me please



canarispott
01-10-2007, 03:52 AM
hi people recent i buy a yamaha banshee. the quad its very fast but I HAVE A BIG PROBLEM.


When I ignite To the first one evericing ok i press the gas and the bike its allready but wen start to put gears up everithing its ok but whe cut the gas and pres gas again the bike fault and one cilinder turn off and on, i stop teh bike to the first gear and satra again to put gears up the bike its ok but the problen is when y cut gas and later pres gas:( .

one day the bike Stranger the bike run perfec but the day after the same histori.

I THINK THE PROBLEN ITS FOT THE CARBURATORS BECAUSE SOME BODY TELL ME THE STHOCK CARBURATORS ITS SO BAD .

SOME BOGY GETS THE SAME PROBLEN.

exhaust tomi racing 5

Kn filter

boost botle

machwon
01-11-2007, 07:13 PM
Sounds like it cuts out when you're on and off the gas???

I would check the pilot jets on the carbs and clean them. The have 8 small holes on the end and an even smaller hole that runs length wise through the jet. The smaller one usually gets plugged and can cause similar issues.

canarispott
01-11-2007, 08:50 PM
i try to do tomorrow and tell wat hapen. thanks again

DareDevilQracer
01-11-2007, 10:19 PM
Did you try putting new spark plugs in it?

canarispott
01-12-2007, 07:50 AM
yes, i check every bike only the carburetors wait;)