idro
01-08-2007, 09:50 PM
Ok, i got the slip on installed, HMF.
ATV won't start, its normally not this hard to start. Like it is VERY VERY cold natured. I couldnt even get it started to do a carb/jet test run
I really don't know if this has anything to do w/ it, but in the instructions it said to remove the header gasket? Um... everyone else did that right? Or what? Is that true or what? In my exhaust experience i thought you needed a gasket between the engine and exhaust pipe?
Also, can anyone link me to a article that tells how to take off your carb? I tried and tried to get the tools i had to my carb jet area and what i had won't reach. Was trying with a socket and i just couldnt get it to fit. I don't have any MM wrenches so im not about to go buy some.
For the most part, im sure my jetting is going to be either 152 or 155... So i think i got that down. Just this cold start is killing me, i think i read something about that somewhere but my internet is being lame and i just can't find it.
Anyone with advice, is well appreciated.
ATV won't start, its normally not this hard to start. Like it is VERY VERY cold natured. I couldnt even get it started to do a carb/jet test run
I really don't know if this has anything to do w/ it, but in the instructions it said to remove the header gasket? Um... everyone else did that right? Or what? Is that true or what? In my exhaust experience i thought you needed a gasket between the engine and exhaust pipe?
Also, can anyone link me to a article that tells how to take off your carb? I tried and tried to get the tools i had to my carb jet area and what i had won't reach. Was trying with a socket and i just couldnt get it to fit. I don't have any MM wrenches so im not about to go buy some.
For the most part, im sure my jetting is going to be either 152 or 155... So i think i got that down. Just this cold start is killing me, i think i read something about that somewhere but my internet is being lame and i just can't find it.
Anyone with advice, is well appreciated.