View Full Version : HiPer Rim Lug Nuts Tapered or Flat?
hornetgod13
01-08-2007, 02:27 AM
I'm getting a set of rims soon and I have a couple questions. Hopefully a few lucky HiPer rim owners can help me out.
HiPer Rim lug nuts a sopposed to be flat right? Do I need to put a washer between the lug nut and the rim?
procircuit406ex
01-08-2007, 08:05 AM
If im not mistaking then yes your right but Im not 100 percent sure...
bradley300
01-08-2007, 09:21 AM
get lugnuts for a stock blaster, they are the kind you need. they ar 17mm at the base, but only 14mm at the head where the socket sits
svahle
01-08-2007, 10:27 AM
Mine require flat lug nuts. Just turn the tapered nuts around and put the tapered side out. I use washers on mine just to be safe.
deathman53
01-08-2007, 03:27 PM
I have no problem with reversed stock honda lugs on mine. Most 17mm sockets fit fine.
Punk'd
01-08-2007, 10:29 PM
I just reversed my stock lug nuts and put a washer in.
nicker71
01-09-2007, 11:00 AM
my stock yfz lugs were fine. Make sure you have a 12 point 3/8 s socket for the ring bolts. I had a hard time finding one.
hornetgod13
01-09-2007, 12:32 PM
Thanks to everyone for your input. I took your advice and went with an oversized flat face lug nut. I like the added surface area to hold the rim in place. They were only $1.00 a piece at www.rockymountainatv.com
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.