TheLadiesMan
01-05-2007, 09:27 PM
ESR 350 package- $1000 + shipping ESR 330 cylinder, ESR +4mm stroker crank, and spacer plate. cylinder is on its 2nd bore and will need to be honed or bored to the next size. it has been ported by the best C-Leigh Racing (Neil) for mid-top. crank and bearings doesn't even have 10 hours on it.
http://72.29.68.184/~despera/stuf%20to%20sell/350R/100_3376.JPG
1988 transmission with yukon gears installed-$450 + shipping the yukon gears dont even have 10 hours on them, perfectly running trans.
http://www.planethondaracing.com/hondaparts/images/schematic/trx250/trx250r-trans-86-89.gif
http://www.planethondaracing.com/hondaparts/images/schematic/trx250/trx250r-gearshftdrm-86-89.gif
1988 cases- $250 + shipping has the usual lower case saver damage. there are 2 bolts are stripped out. cases are set up for a 330 cylinder and +4mm stroker. 95% of the bearings are brand new (10 hours)
http://72.29.68.184/~despera/stuf%20to%20sell/350R/100_3394.JPG
http://72.29.68.184/~despera/stuf%20to%20sell/350R/100_3395.JPG
http://72.29.68.184/~despera/stuf%20to%20sell/350R/100_3396.JPG
clutch assembly- $80+ shipping barnett clutch on it with an hour on it. new pressure plate and inner hub. works good.
http://72.29.68.184/~despera/stuf%20to%20sell/350R/100_3389.JPG
Pro taper fat bars/clamps- $50 + shipping
i will be adding some more parts to it tomorrow. of if you can think of something you need out of the motor let me know.
http://72.29.68.184/~despera/stuf%20to%20sell/350R/100_3376.JPG
1988 transmission with yukon gears installed-$450 + shipping the yukon gears dont even have 10 hours on them, perfectly running trans.
http://www.planethondaracing.com/hondaparts/images/schematic/trx250/trx250r-trans-86-89.gif
http://www.planethondaracing.com/hondaparts/images/schematic/trx250/trx250r-gearshftdrm-86-89.gif
1988 cases- $250 + shipping has the usual lower case saver damage. there are 2 bolts are stripped out. cases are set up for a 330 cylinder and +4mm stroker. 95% of the bearings are brand new (10 hours)
http://72.29.68.184/~despera/stuf%20to%20sell/350R/100_3394.JPG
http://72.29.68.184/~despera/stuf%20to%20sell/350R/100_3395.JPG
http://72.29.68.184/~despera/stuf%20to%20sell/350R/100_3396.JPG
clutch assembly- $80+ shipping barnett clutch on it with an hour on it. new pressure plate and inner hub. works good.
http://72.29.68.184/~despera/stuf%20to%20sell/350R/100_3389.JPG
Pro taper fat bars/clamps- $50 + shipping
i will be adding some more parts to it tomorrow. of if you can think of something you need out of the motor let me know.