Drtridr18
09-21-2002, 01:57 PM
I was about to load up my 400 today, noticed that my front left rim is bent in a bit(brand new .190 Douglas), and if that weren't enough, i noticed my left lower A-Arm is kinked, both bottom tubes, the front is cracked right ahead of the weld. Toys cost too much money...my axle's still bent just a bit too! Ain't that just a pisser??
My question is, can I buy just ONE a-arm for the lower left? I don't care if it's used or not-where would I find one? I checked e-bay but only found a full-used set starting at 80 bones.
Anyone ever bent a dented rim back in? I rode on this thing twice since the little tree stump incident that prolly caused it, never noticed, and the tire doesn't leak air.
Should I look for another single rim used, get one new off R.M., or just bend mine back in the best I can?
Thanks a lot for your help
My question is, can I buy just ONE a-arm for the lower left? I don't care if it's used or not-where would I find one? I checked e-bay but only found a full-used set starting at 80 bones.
Anyone ever bent a dented rim back in? I rode on this thing twice since the little tree stump incident that prolly caused it, never noticed, and the tire doesn't leak air.
Should I look for another single rim used, get one new off R.M., or just bend mine back in the best I can?
Thanks a lot for your help