water troubles

[Mxjunkie]

When I wash my banshee it seems like water allways gets in my damn spark plug boots anyone else have this problem?

[project_tecate]

nope no problems here, are you using a pressure washer? If so just stay clear of the plug boots and wipe them down by hand. Prob forcing water up into them

[Mxjunkie]

garden hose..

[bansheerider4]

yea i always got that to so i decided to wrap towels and what not around it.....:chinese:

[project_tecate]

are you sure its def getting side the plug boots? It can seem its in the boot when you pop them off if theres water still on the outside

[Mxjunkie]

It gets inside because when i go to run it again it runs horrible and I have to take the boots off and blow them dry..

[firefighterjosh]

I never had the problem but I always put water resistant dielectrical grease on the plug wires and on the inside wear the sparkplug touches the wires

[TWILES]

I never did anything to my Banshee plug caps and it always ran fine. I always washed it with a pressure washer and Simple Green.

[bansheerider98]

i had the same problem, do te electrical grease like firefighter josh says, and if it still persists get new boots, some wear out and have more of a chance for water to slip up there.