cutting 250ex fenders

[hondamx82]

I have a 2001, 250ex with a dg bumber, oury grips, and ITP Gncc rear tires. I was wondering if you guys had any info on the proper way to cut fenders, and if you guys could post some pics

[manassashonda]

sell the 250ex and buy a 450R!

[yaks350]

here is a pic of my 300ex

[zack221]

Originally posted by manassashonda
sell the 250ex and buy a 450R!

you didnt have to post that maybe he dont want one i personally dont like 450r's

[enduro400rider]

this is how i did it.

first clean the quad. then take a towel and drape it over one fender and use the edge of the towel to map out ware you want to cut. step back make sure you like it. this step gives you a good idea of how it will look, just picture the area covered by the towel gone. once you have it how you like it. take tape and make a cutting line with the tape. finnaly cut carefully along the line. i prefer a dremel tool with a cut off wheel. its best to cut about a 1/4 inch less off than you want. then you can fine tune it with sand paper or a sanding wheel so both sides are even.

[Ruby Soho]

when i cut fenders i use a jigsaw

[ShiftFMX]

Originally posted by Ruby Soho
when i cut fenders i use a jigsaw

Word :chinese:

http://i89.photobucket.com/albums/k216/ShiftFMX/DSC01746.jpg

[hondarider101]

Originally posted by manassashonda
sell the 250ex and buy a 450R!

all i did was take wire cutters and a tape mearsure and mearsure each 1 how wide i wanted them and thi=en cut them w/ the wire cuttersa and then take a tourch and melt the sides so it looks like they come from the factorie like thatt
:macho