12-12-2006, 03:23 PM
i just changed fibers and plates in my clutch on my 400ex
i soaked the fibers in oil for about 3 hours. also put on a new cable.
here is the problem: when i press the shifter into first gear, the bike immediately jumps forward and stalls.
the cable is adjusted right and i soaked the fibers. could i have put too much tension on the springs? should they have been tightend all the way down? there is enough oil in the bike also...
i am not sure if i put the last friction disk in in a different slot as the others? could this be my problem?
i soaked the fibers in oil for about 3 hours. also put on a new cable.
here is the problem: when i press the shifter into first gear, the bike immediately jumps forward and stalls.
the cable is adjusted right and i soaked the fibers. could i have put too much tension on the springs? should they have been tightend all the way down? there is enough oil in the bike also...
i am not sure if i put the last friction disk in in a different slot as the others? could this be my problem?