GT Thunder link with PRM skid...

[GIXXER1KR]

Anyone running the Gt Thunder rear link with a PRM swing arm skid.If so what did u have to do to get it to fit???

[outlaw450r]

I just cut part of the linkage box off. Just hold it up there, mark it with a pencil and whack away.

[ABrocket]

I just ordered a prm skid from them with no linkage box for by gtt link,

I spaced mine down about 3/8" with some home made spacers. You can just get longer bolts and stack some washers.

[DJJ450r]

Originally posted by TRX450R_Racer
I spaced mine down about 3/8" with some home made spacers. You can just get longer bolts and stack some washers. That's what I did and it works great:macho

[GIXXER1KR]

I just cut off the part that the bottom of the linkage hits.It still has the sides of the box section on the side of the linkage.

[ronnie]

protect make a stanless skid plate for a jt thunder i orderd one yesterday

[JW450R1]

is that gt thunder linkage a dual link,or single?.does any-one have a link to protect?.i cut out my box for a elka dual linkage and just weilded the box lower to the ground.i does work,but its very low to the ground

[GIXXER1KR]

Well i cut the box section of and trimmed it,and trimmed it several times and now my wider spring hits the sides were the linkage box was.What to do next???????????????????Im thinking of cutting it back and just leaving the last four mounting bolts.I gotta do something!!!What are all u cross country guys doing.This link hangs low!!!

[Punk'd]

Originally posted by GIXXER1KR
Well i cut the box section of and trimmed it,and trimmed it several times and now my wider spring hits the sides were the linkage box was.What to do next???????????????????Im thinking of cutting it back and just leaving the last four mounting bolts.I gotta do something!!!What are all u cross country guys doing.This link hangs low!!!

Longer bolts and stack washers?

[parkers30]

you need to widen out the opening for the spring to clear, if you go to 'the other site' there are some pictures posted in the GT thunder section

[Punk'd]

Originally posted by parkers30
you need to widen out the opening for the spring to clear, if you go to 'the other site' there are some pictures posted in the GT thunder section

Where are the pictures posted?