Sparks425Ex
09-15-2002, 07:55 AM
Today i am grindin the welds on my header. I already took it off adn it in my shop ready to be grinded. I have found that there is abotu and 1/8 of and inch all the way around the inside of my header in both pipes.
I was very suprised how much was there and how much flow that could restrict.
So about how much should i grind out.?
Should i make it flat even with teh rest of the pipe or leave a lil in there.?
I was very suprised how much was there and how much flow that could restrict.
So about how much should i grind out.?
Should i make it flat even with teh rest of the pipe or leave a lil in there.?