help help help

[blasterheavyB]

i have a blaster and i am putting a fmf full exhaust on it but when i put it on there was about an inch gap between the end and the manifold what do i need to get rid of that gap

[Xater]

im not sure because fmf has the same length and bend as stock, make sure you put it in right.

[blasterheavyB]

i tried and tried again but there is still a slight gap and the top of the pipe is hitting on the gas tank so it can not go any closer

[red4ever]

just push harder cause somethings gotta give (seriously)

[blasterheavyB]

yeah well i tried to push and it will not go any further then what it is

[Xater]

a picture would be nice but im thinking that you didnt set the pipe in right.

[blasterheavyB]

i will try to get some up but does the pipe actualy go into the head or just set flesh agaisnt the head

[Xater]

it should bolt up flush.

[blasterheavyB]

then man i dont know i have ****ed with it so much and there is still just a little bitty gap very small but noticable that is still there