View Full Version : In need of a cylinder boring an piston
Jared Coderre
11-18-2006, 04:58 PM
Well I have a 400 ex that I just had bored and put a new piston in .020 over and found out the cylinder is .037 out round. see my previous thread
I need a good shop that can bore it fit a new piston and rings to it and turn it around fast.
Anybody here know of a shop that can do this quickly?
Thanks JC
exrider23
11-19-2006, 07:06 AM
ASk c&d racing (site sponsor) they might do it.
Jared Coderre
11-19-2006, 08:15 AM
I have sent him an email. Anyone else have a shop they can reccomend?
2004exrider
11-19-2006, 11:53 AM
Any local machine shop around you should be able to do it for $50 - $60.
Jimmy
exrider008
11-19-2006, 11:56 AM
Originally posted by 2004exrider
Any local machine shop around you should be able to do it for $50 - $60.
Jimmy
yup just look in the phone book...just dont bring it to ur friend:p
Jared Coderre
11-19-2006, 12:48 PM
I am looking for someone to fit a new piston to it etc etc. I don't have a piston now.
I was hoping I could get it sent out tomorrow and get it back in a week or so.
Does anybody know a shop that can do this?
crewworrior
11-20-2006, 10:23 PM
lakesmotorsports@aol.com
lost boyz
11-21-2006, 07:48 AM
just got mine back 1 week ago from gt thunder...
they did my heavy head studs and bored it for me to make it a 416...and even put in my Kibble Whites on all 4 valves....
would highly recommened...
get work and veryyyyyyyyyy fast shipping and turnaround!
Powered by vBulletin® Version 4.2.1 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.