flexx bars w/ hand guards

[crash n burn]

I am looking into getting some flexx bars, but i currently have the acerbis rally2 handguards and i dont know if they will mount on the flexx bars. Does anyone know if they work or how to make them work.

[fastrider450r]

i had the same problem and had to make mounts out of flat steel u no some cuttin and bendin and drilling, and ran a long bolt through the holes were the 2 bar ends connect to the middle piece it made them real strong the only mistake i made was that i didnt heat the metal enough to bend them and they cracked so i had to fill in the cracks with weld but it still worked real well...heres the thread that i did it on.
now i run cycra probends and just had to tilt the mounts a little but they work great...u can then paint of powdercoat them after ur done...mine are supermirror red now
hope this helps


http://www.exriders.com/vbb/showthread.php?s=&threadid=180509&highlight=flexx+bars

[crash n burn]

thanks ill give it a shot