change hubs

[ondagaskiknass]

im puttin 400ex hubs on my 450, how do i do this, i took off the tire and the big nut in the middle, but the brake router is in the way... do i take that off and exchange that too.. if so how? or do i unbolt it from the hub with an allen wrench?

[Pappy]

Remove wheel

Loosen brake caliper and swing upward to allow brake rotor to clear

Loosen spindle nut

Slide Hub assembly off spindle

Remove 3 allen head rotor retaining bolts

Hub is now in hand to do what you would like with.

Reassembly is opposite of disassembly

[ondagaskiknass]

how do i loosen brake calipilar?

[ondagaskiknass]

how do i loosen brake calipilar?

[Pappy]

There are 2 bolts holding the caliper to its mount. remove the rear bolt and loosen the front

[ondagaskiknass]

ok, all that is done but the hub wont slide off, i tried tapping with a hammer and that did not work either. You are talking about wheel hubs right?

[jrm03]

Get a flat screwdriver or pry bar and pry the hub away from the spindle as much as possible then you may have to get a piece of wood and a hammer and tap it off. Don't pry too much on the dust seal on your bearings or you will shred them