can someone post pics of powermadd handguards mounted

[800screws]

i don't know if i'm f'd up or what...no matter where i put them, the clutch lever hits, and i can't figure on where they go on the front brake side! i have a twist throttle also, but i don't think that should affect it. so, can someone give me a break and post a couple of pics on where they mount them! thanks:D

Are raptor had hand gaurds too and the levers would tuch the hand gaurds

http://i108.photobucket.com/albums/n26/getdrunk1990/Andys4whlrmissyscake018.jpg
http://i108.photobucket.com/albums/n26/getdrunk1990/Andys4whlrmissyscake007.jpg
http://i108.photobucket.com/albums/n26/getdrunk1990/Andys4whlrmissyscake008.jpg

[800screws]

do u mount the throttle side between the front master cylinder and the throttle or outside of the front master cylinder and on the clutch side, it's mounted outside of the perch?

I think i mounted them in to the inside

[300exQuadracer]

throttle side is mounted to the inside of throttle and my clutch side i had to run a shorty lever