I've got a LSR +2+4 axle, I NEED an XC axle- 450R

[450RGNCC]

Like the headline says, I've got a Lonestar +2+4 axle on my '04 450R and I need a narrower XC axle. This axle is not bent, and the splines are all good, it just has a few little rust spots on it and its not all shiny like it used to be. If someone has an XC Lonestar or RPM axle, NOT BENT, NO MESSED UP SPLINES, I will trade you straight up. I will consider a stock axle, but again it cannot be bent or have any messed up splines, and you will definitely have to pay extra, so make me an offer. Thanks.

[Pred_003]

My stock axle is like new... how much cash are we talking?

[450RGNCC]

I would need $125 and your axle, but I would highly prefer an aftermarket axle, so I am not going to make any deals on a stock axle yet.

you could always just flip your rims to get skinny.

[450RGNCC]

I was thinking about that, but then I have to take out the center section of the wheel and flip it over, plus that would only gain me an inch on each side, and I need to go a little more than that.