help quick

[exrider23]

what would cause the brakes to not bleed could it be the master cylider

[John Pennella]

I actually just did mine today after replacing swing arm bushings, it took a while for the line to just start spitting out air then after a while, fluid came out. I dont know why but I would just keep pumping the brake and make sure that you keep enough fluid in it too so that it doesn't suk air again.

[brian-250]

Here's a little lesson on brake work hey guys. This goes for all brake work to, i.e. cars, trucks ect.. When getting ready to bleed let gravity do most of the work for you, fill you reservoir up with fluid, open the bleeder on the caliper all the way and wait until fluid runs out, then close the bleeder and pump the brakes and have someone keep slight pressure on the pedal when bleeding. should only take 3 or 4 times for a complete bleed. hope this helps.

[krt400ex]

i like that lady :devil: