Jstbnme
10-24-2006, 02:29 PM
Anyone had success trying to "un-bend" a frame?
I recently tweaked my frame behind the lower left rear a-arm mount and I'm putting it on a car frame machine this week to see what it can do. It's off by about 1/4 inch, but that leads to about 2-3 inches at the wheel ..
I'm in the market for a frame, but going to see what this gets me for the time being.
Any success/fail stories out there?
I recently tweaked my frame behind the lower left rear a-arm mount and I'm putting it on a car frame machine this week to see what it can do. It's off by about 1/4 inch, but that leads to about 2-3 inches at the wheel ..
I'm in the market for a frame, but going to see what this gets me for the time being.
Any success/fail stories out there?