Assembly of the rear axle????????

[grimreaper18]

I got my sprocket hub pressed onto my axle and I tried putting everything back together with all new parts but I have the locking nuts and it doesnt seem to fit if I put the brake rotor on it! i dont understand how this goes back together I wasnt the one who took it apart. PLEASE i need some assistance! Detailed instructions would be nice!

[ImplodedMindZ]

Maybe This (http://216.37.204.203/Honda_OEM/HondaATV.asp?Type=12&A=79) will help u out some, give u an idea of how it goes back together since u didnt take it apart, select your year and wantnot and just go down to REAR AXLE / DRIVE CHAIN gives somewhat detailed diagram of how it goest back together.

[Joe250x]

Hey man, Your link is bad. It brings me to the same page in a new window :(

[ImplodedMindZ]

Sorry link fixed

[grimreaper18]

My problem is that the cylinder otherwise known as the axle nut doesnt have any threading left over on the axle itself after I install the brake rotor. If I dont put on that rotor then it works fine. Ive studied the diagram 100 times and the rotor that I have has a cylinder shaped thing in the middle of it unlike the rotor in the diagram?b

[mrnate400ex]

do you possibly have a 250r axle in there?? if you do, the stock axle lock nut will not be "long" enough to tighten against the ring and the brake hub. you have to use a 250r axle lock nut to make it work. maybe i'm misunderstanding??

[grimreaper18]

It all fits together theres just no threading under the axle nut. Theres grooves on the inside of the cylinder shaped piece that the axle nut locks to. I dont know I think I figured it out, all the help is greatly appreciated!