250Renvy
10-15-2006, 07:49 PM
I'm starting to redo my stock 88 250R that hasn't had anything touched on it since new.
The clutch is super stiff and after about a half hour of riding I can barely pull it in.
How can I get it so it's incredibly easy to pull?
Will replacing the whole setup to new or do I need an ez pull clutch lever? or Hydraulic clutch lever, new cables?
I've had newer 300ex's and 400ex's and those clutches were easy. Help would be greatly appreciated cause I'll probably end up doing 3 clutch setups.
The clutch is super stiff and after about a half hour of riding I can barely pull it in.
How can I get it so it's incredibly easy to pull?
Will replacing the whole setup to new or do I need an ez pull clutch lever? or Hydraulic clutch lever, new cables?
I've had newer 300ex's and 400ex's and those clutches were easy. Help would be greatly appreciated cause I'll probably end up doing 3 clutch setups.