Honda_7x
10-06-2006, 07:32 AM
i recieved 3 washers and their are 4 bolts (each side)i now that the upper a arm ball joint needs one on the very top and the lower a arm ball joint needs one on the very bottom but were does the extra one go or is it realy necessary?
http://i7.photobucket.com/albums/y257/QuadSquad7x/frontend002.jpg
also how tight does this nylon nut get?? untill i fine tune it
http://i7.photobucket.com/albums/y257/QuadSquad7x/frontend004.jpg
and do these bushings look correct ? they just need time to break in correct? because the bolt once to turn with the a arm (just loose)
AND is there a torq spec on them??
http://i7.photobucket.com/albums/y257/QuadSquad7x/frontend006.jpgBottom ONE
http://i7.photobucket.com/albums/y257/QuadSquad7x/frontend005.jpg
top one
thanks for the help
http://i7.photobucket.com/albums/y257/QuadSquad7x/frontend002.jpg
also how tight does this nylon nut get?? untill i fine tune it
http://i7.photobucket.com/albums/y257/QuadSquad7x/frontend004.jpg
and do these bushings look correct ? they just need time to break in correct? because the bolt once to turn with the a arm (just loose)
AND is there a torq spec on them??
http://i7.photobucket.com/albums/y257/QuadSquad7x/frontend006.jpgBottom ONE
http://i7.photobucket.com/albums/y257/QuadSquad7x/frontend005.jpg
top one
thanks for the help